BFCM 2023

Rear lower outer pivot pins. Hardened steel, 4mm thick. Set of 2.

Rear lower right suspension arm made from tough molded composite - hard rigidity.

Right rear hub carrier. Features 3 upper camber link mounting positions, and 2 lower pin roll-center positions.

Left rear hub carrier. Features 3 upper camber link mounting positions, and 2 lower pin roll-center positions.

Mounted rear foam tires (40deg - medium) on solid dish rims for use with drive shafts with hex adaptors ONLY. Will not fit on original M18 with ori...

XRAY presents +1mm height-adjustable body posts for the T2 and NT1. For serious racers who focus on the small details, body height plays a very imp...

Rear body mounts, complete set.

Rear lower outer pivot pins. Hardened for very high durability and long life. Set of two.

Rear anti-roll bar 2.8mm thick.

New for the NT1 is this adjustable rear anti-roll bar set that allows you to quickly and easily adjust rear anti-roll bar stiffness without replaci...

Roll-over bar made from spring steel. Also acts as convenient carrying handle.

All-new design RIGHT steering block features increased steering angle for improved steering and cornering speed, and a new Ackermann position for i...

Molded composite RIGHT steering block redesigned to allow the mounting of graphite aerodynamic disks. The tiny yet tough steering blocks are molded...

Molded composite relief steering ball joint for mounting on M4 turnbuckle, attaches to 5.8mm pivot ball. Set of 2.

Molded composite relief steering ball joint for mounting on M3 turnbuckle, attaches to 5.8mm pivot ball. Set of 2.

PUR® reinforced rear drive belt 8.0 x 204mm. Very thin and elastic for an extremely efficient, low-friction drivetrain.