Xray NT1 Parts

Molded composite 4.9mm ball joints, open on both sides, for connection to 4.9mm ball. Set of eight. Fits XRAY T2, T3, T4, RX8, XB8, NT1, X1 and GTX8

Threaded 4.9mm ball end with 8mm thread length for connection to molded ball joints. Set of 2.

Eccentric bushings for adjusting suspension settings, made from tough composite. Fits XB4 alu suspension holders. Using eccentric suspension bushi...

XRAY rear spring set for NT1. Different spring tensions to fine tune your car. Powder-coated for easy identification. Developed from extensive test...

Rubber O-ring fits over 5mm shaft. 1mm thick. Set of 10 pieces.

Threaded 4.9mm ball end with 10mm thread length for connection to molded ball joints. Set of 2.

Threaded 4.9mm ball end with 5mm thread length for connection to molded ball joints. Set of 2.

Alu shims 3x6mm size, 2mm thick, set of 10. Available in Black, Orange and Silver

Threaded 4.9mm ball end with 6mm thread length for connection to molded ball joints. Set of 2.

5mm dia. E-clip. Set of 10 pieces.

Front body mount set includes redesigned 6mm-thick bodyposts and all other mounting hardware. Fits XRAY T2 and NT1.

Alu shims 3x5mm, 1mm thick which can be used for various purposes including roll center adjustment - Set of 10. Available in Silver or Orange

Alu shims 3x6mm size, 4mm thick, set of 10. Available in Black & Silver

Molded composite 4.9mm ball joints for anti-roll bar links, same as included in anti-roll bar sets #302401 (front) and #303401 (rear). Set of 4.

XRAY rear spring set for NT1. Different spring tensions to fine tune your car. Developed from extensive testing and racing experience, these racing...

3S springs have been specifically designed to complement the LP shocks and the rear springs are 4mm shorter than previous NT1 springs.The front and...

M3 nylock nut. Set of 10 pieces.

Ultimate-match coil shock springs for pan cars and formula front suspension offer an additional range of choices to fine-tune your car. Powder colo...

High-performance clutch bell ball-bearings 5x10x4. Packed with grease specially made for clutch bell. Qty of 2.

XRAY rear spring set for NT1. Different spring tensions to fine tune your car. Powder-coated for easy identification. Developed from extensive test...

Lower bumper made from tough composite material.

Molded composite server saver pieces, including 2 Ackermann inserts.

Ferodo® fiber brake pads for NT1, must be glued onto #334120 steel brake pads. Set of 2.

Polished steel pins for gear differential. Set of 2.