Xray Parts

XRAY precision-molded offset spur gear 72T 48P, strategically lightened to reduce rotating mass.

The unique CFF suspension arms are an elegant engineering achievement that look great and perform even better on the track. Using XRAY's own newly ...

This is a pack of four replacement XRAY Differential Gaskets, and is intended for use with the XRAY T3 family of 1/10 touring cars equipped with th...

Optional specially-modified high-performance Kevlar®-reinforced 513mm-long, 3mm-wide front drive belt.This belt is very thin and elastic as possib...

Optional specially-modified high-performance Kevlar®-reinforced 189mm-long, 3mm-wide rear drive belt.This belt is very thin and elastic as possible...

Molded composite C-hub for right steering block of T2, T3. Caster pre-set at 4°. Medium rigidity for rubber-tire racing. Use with matching left-si...

Threaded 4.9mm ball end with 8mm thread length for connection to molded ball joints. Set of 2.

Molded composite C-hub for right steering block of T2, T3. Caster pre-set at 4°. Medium rigidity for rubber-tire racing. Use with matching left-si...

The unique CFF suspension arms are an elegant engineering achievement that look great and perform even better on the track. Using XRAY's own newly ...

Eccentric bushings for adjusting suspension settings, made from tough composite. Fits XB4 alu suspension holders. Using eccentric suspension bushi...

78-tooth large external spur gear for center differential. Molded from specially-formulated tough composite material. Tooth number stamped for easy...

Optional spur gear for 3-Pad Slipper Clutch. Precision-molded slipper clutch spur gear 75T 48P is made from XRAY's exclusive secret blend of compos...

XRAY rear spring set for NT1. Different spring tensions to fine tune your car. Powder-coated for easy identification. Developed from extensive test...

X4 BB Gear Differential - Set

Suspension pivot pins, hardened for very high durability and long life, polished for smooth operation. Used on inboard pivot point of XB4 suspensio...

Set of composite molded parts for 2 shock absorbers, includes upper shock cap, lower spring retaining collar and ball joints.

Rubber O-ring fits over 5mm shaft. 1mm thick. Set of 10 pieces.

Silicone O-ring fits over 24mm shaft. 0.7mm thick. Set of 10 pieces.

Precision-molded 20T layshaft pulleys for XRAY T2’008, T2'009 and T3 includes composite shims. Standard pulleys for XRAY T2’008, T2'009, T3 US Foa...

Narrow high-performance pinion gear manufactured from special lightweight aircraft duraluminum is 1.5mm thinner and 25% lighter than the regular-s...