Losi 5T

DDM tall velocity stack and gasket. 30.5mm center to center bolt hole spacing. Longer intake tract for improved performance. 1" height. Diameter is...

Outerwears brand pre-filter. 3" diameter, 2.5" height. Elastic-cinch base for a secure fit. A must-have for operating in dirty or dusty conditions...

Ever found it annoying to pull off the stock clips? This problem is solved! Not only do these "easy grip" clips look great, they work great too. No...

  Rovan NEW stealth light weight 8,000rpm clutch set. Set includes:New Light weight clutch shoes8,000rpm Clutch SpringMounting Hardware Also suites...

New pre-filters made by Outerwears for the DT1 Large Scale R/C Filters.When DT1 teamed up with TGN to bring an exclusive line of foam filters to t...

I-KILLY II - The 2nd generation of RC Engine Kill switch that redefines the safety and protection of your vehicle from running away and protect the...

Features Kills your 2-cycle gas engine on command, loss of radio signal, low battery, or total battery power loss Comes ready to install — no sol...

High Response Clutch Shoe/Spring Set Initial Engagement point: 8,000RPMFull Engagement Point: 10,500RPM HPI Part #: 15448

Micron1T - the next generation of Programmable RC Engine Kill Switch for 2-stroke gas engine. Designed and made in Australia, it works with most 2,...

The Super Bee kit is the #1 must-have hopup for any 2-cycle gas RC.  Stop Runaways!  Works on most all gas RC cars and trucks including HPI Baja, L...

This High Performance clutch shoe/spring set provides more punch off the line. The stock CY clutch spring used in the HPI Baja 5b engages at approx...

RCEKS-5G - the 5th Generation of the 2-stroke RC engine kill switch designed and made in Australia. With new updated firmware and wider operating v...

Walbro Carburettor Metering Diaphragm Assembly for WT / WA series carburettors. This is the same part that comes in the rebuild kits, we are just ...

Outerwears brand drawstring pre-filter for HPI Baja 5B/5T stock air filter. This prefilter will fit your stock air filter only. A must-have for op...

Clutch shoe bellville washer for Zenoah engines with 54mm clutch. Fits between clutch shoe mount bolt and clutch shoe. PMW part # 4334 Zenoah par...

One (1) clutch shoe shim washer for Zenoah engines with 54mm clutch. Installs between clutch shoes and clutch plate. PMW part # 4333. Zenoah part...

Zenoah 54mm stock 6000 rpm clutch shoe and spring kit. Fits Zenoah and Chung Yang engines with 54mm clutches. The two holes for the mount bolts ar...

Zenoah G320RC 54mm Clutch Housing - (SHORTY MODIFIED VERSION - For Losi, Redcat etc) - this is the stock Zenoah G320RC housing that is taken and ap...

Zenoah clutch shoe mount bolt for 54mm clutch. Has 8mm sleeve. PMW part # 4332. Zenoah part # 1140-51250. This item is part of FG part # 07318