Superstock Teams

Low-friction 3.5mm drive pin clips for protecting and cushioning drive shaft pin in diff outdrives. Made from all-new, extra-strong composite mixt...

Molded composite 4.9mm ball joints, open on both sides, for connection to 4.9mm ball. Set of eight. Fits XRAY T2, T3, T4, RX8, XB8, NT1, X1 and GTX8

Molded composite C-hub for right steering block of T2, T3. Caster pre-set at 4°. Medium rigidity for rubber-tire racing. Use with matching left-si...

Molded composite C-hub for right steering block of T2, T3. Caster pre-set at 4°. Medium rigidity for rubber-tire racing. Use with matching left-si...

Molded-composite rear upright features built-in 0° of outboard toe to improve traction and prevent suspension geometry changes in serious crashes....

  Specially-modified high-performance 351mm-long and 3mm-wide drive belt. This belt is very thin and elastic as possible for an extremely effective...

Molded composite steering ball-joint for T2 family of cars and T3. Fits 5mm pivot ball or ball stud. Set of 4.  The closed ball joint prevents du...

Complete gear differential set for XRAY T3 includes composite differential case and cover with pulley. Differential gears are made from tough compo...

Threaded 4.9mm ball end with 10mm thread length for connection to molded ball joints. Set of 2.

Silicone O-ring fits over 24mm shaft. 0.7mm thick. Set of 10 pieces.

Molded composite front lower suspension arm made from hard material. 2mm longer to better fit new suspension mounts. Fits T4’14. After extensive te...

Lower inner pivot pins for XRAY T4’14 onwards. Hardened for extra-high durability and long life. Set of 2.

Alu shims 3x6mm size, 1mm thick, set of 10. Available in Black, Orange or Silver

Threaded 4.9mm ball end with 5mm thread length for connection to molded ball joints. Set of 2.

Molded-composite rear upright features built-in 0° of outboard toe to improve traction and prevent suspension geometry changes in serious crash...

Specially-modified high-performance 189mm-long and 3mm-wide rear drive belt comes standard in XRAY T2’009 Rubber-Spec Conversion Set – 38T Pulley.T...

Threaded 4.9mm ball end with 6mm thread length for connection to molded ball joints. Set of 2.

Aluminum screw removes excessive radial play of the steering to improve the steering precision. Machined from lightweight Swiss 7075 T6 aluminum, b...

Low friction 3.5mm drive pin clips for protection and cushioning of drive shaft pin in diff outdrives. Set of 4. For use only with XRAY T2'008 alu...

Narrow high-performance pinion gear manufactured from special lightweight aircraft duraluminum is 1.5mm thinner and 25% lighter than the regular-s...

Gear differential case and cover made from tough composite material. Used for front or rear differentials. Fits #304900 composite gear differential.

Narrow high-performance pinion gear manufactured from special lightweight aircraft duraluminum is 1.5mm thinner and 25% lighter than the regular-s...

Molded composite steering ball-joint for XRAY XII Link. Fits 4.2mm pivot ball or ball stud. Set of 4.

Alu steering blocks with ultra-strong construction provides very long life and durability in even the most extreme racing conditions. Composite bus...