XRAY Legacy Parts

Differential spring for ball differential.

Molded composite steering block of “hard” hardness (H) for foam-tire racing. The steering block features two Ackermann positions, and uses small b...

Low-friction 3.5mm drive pin clips for protecting and cushioning drive shaft pin in diff outdrives. Made from all-new, extra-strong composite mixt...

Molded composite 4.9mm ball joints, open on both sides, for connection to 4.9mm ball. Set of eight. Fits XRAY T2, T3, T4, RX8, XB8, NT1, X1 and GTX8

Molded composite C-hub for right steering block of T2, T3. Caster pre-set at 4°. Medium rigidity for rubber-tire racing. Use with matching left-si...

Molded composite C-hub for right steering block of T2, T3. Caster pre-set at 4°. Medium rigidity for rubber-tire racing. Use with matching left-si...

Molded-composite rear upright features built-in 0° of outboard toe to improve traction and prevent suspension geometry changes in serious crashes....

Molded composite steering ball-joint for T2 family of cars and T3. Fits 5mm pivot ball or ball stud. Set of 4.  The closed ball joint prevents du...

Complete gear differential set for XRAY T3 includes composite differential case and cover with pulley. Differential gears are made from tough compo...

Threaded 4.9mm ball end with 10mm thread length for connection to molded ball joints. Set of 2.

Molded composite 4.9mm ball joints, special construction. For connection to 4.9mm ball. Set of four. Fits XRAY T2, T3.

Alu shims 3x6mm size, 1mm thick, set of 10. Available in Black, Orange or Silver

Threaded 4.9mm ball end with 5mm thread length for connection to molded ball joints. Set of 2.

Molded-composite rear upright features built-in 0° of outboard toe to improve traction and prevent suspension geometry changes in serious crash...

Specially-modified high-performance 189mm-long and 3mm-wide rear drive belt comes standard in XRAY T2’009 Rubber-Spec Conversion Set – 38T Pulley.T...

Threaded 4.9mm ball end with 6mm thread length for connection to molded ball joints. Set of 2.

Low friction 3.5mm drive pin clips for protection and cushioning of drive shaft pin in diff outdrives. Set of 4. For use only with XRAY T2'008 alu...

Gear differential case and cover made from tough composite material. Used for front or rear differentials. Fits #304900 composite gear differential.

Set of 2 left & right (identical) alu arms for dual servo saver. Ultra-strong construction provides long life and durability in even the most e...

Molded composite 4.9mm ball joints for anti-roll bar links, same as included in anti-roll bar sets #302401 (front) and #303401 (rear). Set of 4.

Silicone O-ring fits over 3.5mm shaft. 2mm thick. Set of 10.

CNC-machined highest-quality duaraluminum C-hub for right steering block of T2, T3. Caster pre-set at 4°. Engraved with "R4" to easy identificatio...

Gear differential precision internal gears made from tough composite material. Includes 2 bevel gears and 4 satellite gears. Also fit NT1 gear diff...

Adjustable left & right M3 steering turnbuckles manufactured from strong, lightweight 7075 T6 aluminum. Precision hreading for fine toe adjust...