XRAY Parts

CNC-machined highest-quality aluminum RIGHT & LEFT C-hub for ARS suspension. Caster pre-set at 2 degrees. Helps to generate more traction but i...

Molded ball-differential 53T bevel gear made from tough composite material.

Tough molded composite radio plate allows for mounting the receiver and speed controller for quick & easy removal and assembly. The integrated ...

CNC-machined eccentric mounting plate made from premium Swiss 7075 T6 aluminum. The motor is connected to this eccentric mounting plate with the as...

REAR linear springs have been specifically designed to complement the big bore shocks. Spring rate is constant during the entire spring compression...

Steering block graphite extension, works on either left or right side. Allows for easy Ackermann position adjustment for fine-tuning on all surface...

Spring steel anti-roll bar, 1.6mm thick. Marked with 6 laser-engraved lines for easy identification. This optional anti-roll bar offers different a...

Optional spur gear for 3-Pad Slipper Clutch. Precision-molded slipper clutch spur gear 87T 48P is made from XRAY's exclusive secret blend of compos...

Precision-molded spur gear 84T is made from XRAY's exclusive secret blend of composite material, allowing the gear to run yet be robust enough to h...

Precision-molded spur gear 81T is made from XRAY's exclusive secret blend of composite material, allowing the gear to run yet be robust enough to h...

Differential spring for ball differential.

Ultimate assortment of set-up shims. You can use the shims for easy and accurate adjustment of:• front and rear roll center• front bump steer• fron...

Molded composite adjustable ball-bearing hub. Set of 4

Molded composite steering ball-joint for T2 family of cars and T3. Fits 5mm pivot ball or ball stud. Set of 4.  The closed ball joint prevents du...

The aluminum shock absorbers have been specially developed to lower the CG of the car to improve stability. With the new SLP shocks, the car stays...

Molded composite steering block of “hard” hardness (H) for foam-tire racing. The steering block features two Ackermann positions, and uses small b...

Low-friction 3.5mm drive pin clips for protecting and cushioning drive shaft pin in diff outdrives. Made from all-new, extra-strong composite mixt...

Molded composite 4.9mm ball joints, open on both sides, for connection to 4.9mm ball. Set of eight. Fits XRAY T2, T3, T4, RX8, XB8, NT1, X1 and GTX8

The unique CFF suspension arms are an elegant engineering achievement that look great and perform even better on the track. Using XRAY's own newly ...

New X4 Alu Hub - Swiss 7075 T6• Alu hubs for X4• Ultra-strong• Long life• Reduces flex• Improves consistency• Full height adjustability• Mainly for...

Molded composite C-hub for right steering block of T2, T3. Caster pre-set at 4°. Medium rigidity for rubber-tire racing. Use with matching left-si...

Molded composite C-hub for right steering block of T2, T3. Caster pre-set at 4°. Medium rigidity for rubber-tire racing. Use with matching left-si...

Molded-composite rear upright features built-in 0° of outboard toe to improve traction and prevent suspension geometry changes in serious crashes....

X4 BB Gear Differential - Set