XRAY Parts

Narrower fuel tank allows for improved fuel movement for more stable and consistent engine operation, mainly at lower fuel levels.The 125cc fuel ta...

Front wheel axle with 1mm less trail ensures increased cornering speed, especially for spec classes in high traction conditions.The axle features p...

Front middle shaft CNC-machined from world-renowned HUDY Spring Steel™. The front middle shaft is highly wear resistant at contact points, helping ...

Ultimate-match front coil springs for pan car front suspension with 4mm king pin axle offer an additional range of choices to fine-tune your car. P...

Exhaust wire mount set includes the mounting wire, composite support, and all necessary hardware.

ECS Drive Shaft Case made from HUDY Spring Steel™. Fits #365200 and #365300 ECS drive shafts.

CNC-machined CVD drive shaft coupling. Made from world-renowned HUDY Spring Steel™. Specially hand-ground for maximum precision.

The rear uprights are molded from the harder composite mixture to maintain proper suspension geometry and to provide more stability and accuracy co...

Hard molded composite rear upright with 2 roll-center positions, made from super-tough high-tech composite material. Its compact size and strength ...

Composite side spring holder for straight and also for tapered side springs. Set of 2.

Molded-composite right steering block for XRAY RX8 with built-in +1° kingpin angle. Marked "R" and "+" for easy identification. Use with matching #...

Molded-composite left steering block for XRAY RX8 with built-in +1° kingpin angle. Marked "L" and "+" for easy identification. Use with matching #3...

Molded composite servo mount for XRAY XII features angled mounting faces to reduce unwanted bump steer. Set of 2.

Carbon Pivot Brace Bushing is part of the aluminum Tweak-Free Pod Mounting System which improves traction and stability of the car and eliminates t...

Complete set of molded composite parts for XRAY X12 center dampener #378102

Super smart XRAY Snap Lock™ bushings replace locknuts and aluminum bushings, reduce weight and stay securely held in place after installation. Set ...

Molded composite front anti-roll bar mount set. The front anti-roll bar is fully independent from downstop adjustment.

Tough composite chassis wire cover that routes wires between the motor and electronics through the center channel of the front chassis brace, preve...

Tough composite chassis cover that routes the wires between the motor and electronics through a center chassis channel so they do not interfere wit...

Tough composite side guards designed to fit the chassis closely, helping seal out dirt and protect from side impacts. Redesigned to match the XB4’2...

Tough composite side guards that fit the chassis closely to help seal out dirt and protect from side impacts. Made from hard composite material and...

Rear graphite brace made from a graphite composite that gives stiffer chassis flex than the hard brace, making it better suited to higher-grip surf...

Front brace made from tough composite material. It mounts to the aluminum chassis to reinforce the chassis assembly and deliver the desired flex. M...

Tough, rigid composite central bulkhead that allows easy access to the central slipper clutch system.