Xray

Hard molded composite rear lower suspension arm. Recommended for use in standard conditions or with rubber tires. Marked with 'H' for easy identifi...

Rear shock shaft made from 3.5mm diameter hardened steel. Polished for smooth operation. Set of 2.

Rear lower outer pivot pins. Hardened steel, 4mm thick. Set of 2.

Rear lower right suspension arm made from tough molded composite - hard rigidity.

Right rear hub carrier. Features 3 upper camber link mounting positions, and 2 lower pin roll-center positions.

Left rear hub carrier. Features 3 upper camber link mounting positions, and 2 lower pin roll-center positions.

Mounted rear foam tires (40deg - medium) on solid dish rims for use with drive shafts with hex adaptors ONLY. Will not fit on original M18 with ori...

XRAY presents +1mm height-adjustable body posts for the T2 and NT1. For serious racers who focus on the small details, body height plays a very imp...

Rear body mounts, complete set.

Rear lower outer pivot pins. Hardened for very high durability and long life. Set of two.

Rear anti-roll bar 2.8mm thick.

New for the NT1 is this adjustable rear anti-roll bar set that allows you to quickly and easily adjust rear anti-roll bar stiffness without replaci...

Roll-over bar made from spring steel. Also acts as convenient carrying handle.

All-new design RIGHT steering block features increased steering angle for improved steering and cornering speed, and a new Ackermann position for i...

Molded composite RIGHT steering block redesigned to allow the mounting of graphite aerodynamic disks. The tiny yet tough steering blocks are molded...

Molded composite relief steering ball joint for mounting on M4 turnbuckle, attaches to 5.8mm pivot ball. Set of 2.